网赌最好最大平台-十大网赌信誉平台-登录

CLASSIFY
Industry information
Location:Home > English > News > Industry information >
The correct welding method of light touch switch needs steps

Release time:2019-04-18    Clicks: Click

 
Our light touch switch must be welded before use. Specific welding methods and steps are introduced to you. I hope you must pay attention to these problems when using them.
网赌最好最大平台
Touch switch, as its name implies, is an electronic switch, which belongs to the category of electronic components.
In addition, the light touch switch, also known as the key switch, first appeared in Japan when it was used to satisfy the operating conditions and close the pressure switch function in the direction of switching operation. When the pressure was withdrawn, the switch was disconnected. Its internal structure was realized by the force change of metal fragments.
1. For the setting of welding conditions, it is necessary to confirm the actual batch production conditions.
2. When welding twice, please do it after the first welding part is restored to normal temperature. Continuous heating may deform the periphery, loosen the terminals, drop off and reduce the electrical characteristics.
3. When welding lightly touched switch terminals, if the load is applied on the terminals, there will be loosening, deformation and deterioration of electrical characteristics due to different conditions. Please pay attention to the use.
4. When using through-hole PCB and PCB other than recommended, due to the influence of thermal stress will change, so please confirm the welding conditions in advance.
Product display
Click here to send me a message

网赌最好最大平台|十大网赌信誉平台

XML 地图 | Sitemap 地图