Some common problems on the micro switch can be handled by some special circuit problems. Can you solve this problem? Now let me give you a detailed introduction.
The spring belongs to a contact device in the whole switch, so its elastic limit needs to be mastered. The general user does not know what range the elastic limit is in, but in the process of touching, it can be found that if the touching is successful, there will be a slight vibration, so it does not need too much force, of course, in the touch touch touch touch control requirements. It is the best way to find high-end manufacturers. Fretting switch is mainly used in the mouse, this product needs buttons in the process of use, so the gasket processing should be very good, the manufacturer needs to give the best guarantee on the contact effect of the lever section. Fretting is to complete the work without using too much force in the click process, and this is in the touch effect. Products can bring people a good experience.
There are many types of micro-switch, which can be divided into many types according to volume or internal construction, but the application effect is roughly the same and the principle of fabrication is the same. First of all, the degree of sensitivity can be satisfied. The most critical of electronic products is the degree of sensitivity, regardless of the application effect. How many areas do you divide? If you can't satisfy your customers with sensitivity, the product will eventually be eliminated by the market. In the micro switch industry, what factories need to do is to do the best in dealing with each component, especially the reaction degree of shrapnel.